Menu path: UMS Administration > Global Configuration > Server Network Settings
Online Check Parameters
Disable online check
The online check is disabled.
Timeout (ms): Specifies how long the system will wait for a response to an online status query message. The UMS attempts to contact all devices that are currently visible in the UMS Console. Each device in this area must respond to the status query in the specified time or will otherwise be flagged as “offline”. Minimum: 100; maximum: 10000; default: 1000
Changed Values on Update
The maximum and minimum value and the new default value have been introduced with UMS 6.04.100. If you update to version 6.04.100 from an older version, the value will be handled as follows:
- If the value was between 100 and 10000, it remains unchanged.
- If the value was lower than 100, it is changed to 100.
- If the value was the old default value of 100, it is changed to the new default value 1000.
- If the value was higher than 10000, it is changed to 10000.
Specify online check port (UDP)
You specify the port to which the devices respond if the UMS checks their online status.
The UMS will select any free port.
Scheduled Jobs
Scheduled jobs never expire
No time limit for scheduled jobs
Expiration time for scheduled jobs: Time in minutes after which a scheduled job will expire. (Default: 40)
Scan Parameters
Timeout (ms): Specifies how long in milliseconds the UMS will wait for a response to scan packages. (Default: 6000)
Broadcast IP: Broadcast address that is used for scan packages. It is only used for scanning the local network. If IP ranges are used, the UDP packets will be sent to each client within the IP range. (Default: 255.255.255.255)
Specify scan reply port (UDP)
You specify the port to which the devices respond if the UMS scans for devices
The UMS will select any free port.