Skip to main content
Skip table of contents

Disassembly Guide of UD7 H830C

This step by step guide shows you how to skillfully disassemble IGEL UD5/6 model H830C.

Pay particular attention to the Safety Instructions!

16563-20240710-100015.png

WARNING

  • The disassembly of the device must only be carried out by an electrically qualified person.

  • Touching live parts can cause danger to life and limb from electric shock.

  • Disconnect the device from the power supply before the disassembly.

  • Disconnect all peripherals from the device before the disassembly.

  • Use only insulated tools for the disassembly.

Read this guide carefully and in full. Perform the steps in the given order.

Back Panel
Battery
Bottom Cover and Chassis
Card Reader (If Available)
Connectivity Bar (If Available)
Disposal
DVI-VGA-Adapter
Foot Stand
Heat Sink
Mainboard
Metal Panel
PCIe Connector Board
Power Supply Cable
Power Supply Unit
Preparation
Rear Outer Casing
Rubber Feet
Safety Instructions of UD7 H830C
Serial Ports
Speaker and USB Board
Tactile Sensor, LED and Front Cover
Tools and Equipment
Transponder
Upper Cover

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close