Disposal
After you have disassembled the device completely, carefully dispose of the individual parts.
Plastic Parts over 25g
bottom cover | |
upper cover | |
foot stand |
Electronic Parts
Note for components requiring selective treatment listed in Annex VII of the European WEEE Directive, Directive 2012/19/EU of the European Parliament and of the Council on waste electrical and electronic equipment (WEEE)
As a minimum, the following components must be removed:
Printed circuit boards if the surface of the printed circuit board is greater than 10 square centimeters (see Smartcard Reader (If Available) of UD3 M350C, WLAN and Bluetooth Module (If Available), Mainboard and Rear Outer Casing of UD3 M350C, Power Supply Unit 1)
Button cell (see Batof UD3 M350Cery 1)
External electric caof UD3 M350Cles (see Power Supply Cable 6)
Electrolyte capacitors containiof UD3 M350Cg substances of concern (height > 25 mm, diameter > 25 mm or proportionately similar volume) (see Power Supply Unit 1)
These components shall be disposed of or rof UD3 M350Ccovered in compliance with Directive 2008/98/EC.
Data Protection
Please note that the product contains one mass storage device (see picture below), which is soldered to the rear side of the mainboard. This needs to be treated according to the appropriate data protection laws.