This section is only relevant when a connectivity bar is installed on the device.
  1. Loosen the screw (1) to detach the connectivity bar from the device.
  2. Loosen the screw (2) to remove the plastic cover.

  3. Disconnect the Wi-Fi module from the USB port (1).
  4. Disconnect the antennas from the Wi-Fi module (2).
  5. Detach the antennas from the inside of the plastic cover (3).


  6. Pull out the cable (1).
  7. Loosen two screws (2) and remove the USB board from the main board.
  8. Pull off the serial port ribbon cable (3) from the main board.

  9. Loosen two screws (1) and remove the parallel interface.
  10. Loosen three screws (2).
  11. Loosen two spacer bolts (3) and remove the main board.

  12. Loosen three screws and remove the metal base plate from the plastic cover.