Skip to main content
Skip table of contents

Updating the Firmware using the Linux Console

Issue

You have to update the device's firmware without IGEL Universal Management Suite or local IGEL Setup application.

Solution

The device's firmware update can also be carried out directly on the Linux console itself without IGEL Setup:

  1. Restart the device.

  2. Press [ESC ]key during booting to bring up the boot menu.

  3. Select Verbose Boot from the boot menu.

  4. When instructed, switch to the console by pressing [CTRL-ALT-F11] or [CTRL-ALT-F12].

  5. Press [RETURN ]key to log in.
    You may have to enter your password.

Carry out the update. The exact procedure varies according to the protocol which is to be used, that is, FILE, HTTP, or FTP; see the instructions below. You can check whether the correct parameter values have been passed using the get command, e.g. get update.protocol

HTTP

  1. If necessary, set up a static IP address (DHCP is active by default)
    setparam network.interfaces.ethernet.device0.usedhcp false
    setparam network.interfaces.ethernet.device0.manual true
    setparam network.interfaces.ethernet.device0.ipaddr
    setparam network.interfaces.ethernet.device0.netmask

  2. Configure the update server
    setparam update.protocol http
    setparam update.http.server
    setparam update.http.port

    The default UMS port is 9080


    setparam update.http.path
    setparam update.http.user
    setcryptparam update.http.crypt_password

  3. Start the update process in the / directory using the command update

FTP

  1. If necessary, set up a static IP address (DHCP is active by default)
    setparam network.interfaces.ethernet.device0.usedhcp false
    setparam network.interfaces.ethernet.device0.manual true
    setparam network.interfaces.ethernet.device0.ipaddr
    setparam network.interfaces.ethernet.device0.netmask

  2. Configure the update server
    setparam update.protocol ftp
    setparam update.ftp.server
    setparam update.ftp.port

    The default port is 21


    setparam update.ftp.path
    setparam update.ftp.user
    setcryptparam update.ftp.crypt_password

  3. Start the update process in the / directory using the command update

FILE

Requirement: The unpacked update files are available in the root directory of a USB storage device.

  1. Configure at least one hotplug USB device:
    setparam devices.hotplug.usb-storage.numdevices 1

  2. Apply your changes:
    kill_postsetupd

  3. Connect the USB storage device to the device.

  4. Wait for the USB storage device to be mounted automatically.

  5. Determine the mount point:
    ls /media/

  6. Configure the update parameters:
    setparam update.protocol file
    setparam update.file.path /media/<name of USB storage device>

  7. Start the update process in the / directory using the command update

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.