Using Disk Utility

To obtain information regarding a hotplug storage device connected to your thin client, proceed as follows:

1. Start the Disk Utility function. The start options are described under Disk Utility.
2. Click on the desired hotplug storage device in the left-hand column.
   The information regarding the hotplug storage device is shown in the right-hand column.

To remove a hotplug storage device safely, proceed as follows:

1. Start the Disk Utility function. The start options are described under Disk Utility.

2. Click on the Safely Remove Hardware button in the right-hand column.
   The hotplug storage device is disconnected from the thin client. Once it has been disconnected, the storage device can be removed from the thin client.

   

   If Setup > Devices > Storage Devices > Storage Hotplug > Hotplug beep is enabled, a signal tone will signal that the device has been disconnected successfully. If Setup > Devices > Storage Devices > Storage Hotplug > Hotplug message is enabled, a message window will signal that the device has been disconnected successfully. Further information can be found under Storage Hotplug.