Menu path: Setup > System > Firmware Customization > Custom Commands > Network

The commands defined here are executed each time that the relevant network interface (default: eth0) starts. The network interface can be selected with the $INTERFACE environment variables (eth0, eth1, wlan0). You can define commands for the execution times described below:

Network initialization

  • Network authentication successful (802.1x or WPA)
  • No further network settings used

After network DNS

  • Runs after each change in the IP address or host name
  • IP address / name server settings used (e.g. via DHCP)

Before network services

  • IP address / name server settings used
  • VPN connected (if VPN autostart was enabled in the setup)
  • No network / host routing settings used

Final network command

  • Network / host routing settings used
  • NFS and SMB drives available
  • System time synchronized with time server
  • UMS settings retrieved but not effective yet