Menu path: Setup > System > Firmware Customization > Custom Commands > Post Session

For a specific session type, you can define an action that is performed when the last session of this type is ended.

Session type: Session type for which the action is performed.
Possible values:

  • No post-session command
  • Citrix
  • Citrix via Browser
  • RDP
  • VMware Horizon
  • Browser
  • NoMachine NX
  • Parallels Client
  • PowerTerm terminal emulation
  • ThinLinc
  • X session
  • IBM iAccess
  • Media player
  • VNC viewer

Post session command: Action that is carried out after the end of the session selected above.
Possible options:

  • Logoff: The user is automatically logged off; a login method must be defined for this purpose. Further information can be found under IGEL Smartcard, Active Directory / Kerberos and Smartcard.

    The “Logoff” option cannot be used if the Appliance Mode is in use. Further information can be found under Appliance Mode.
  • Shutdown/suspend (system default action): The device will be shut down or placed in a standby mode depending on the setting under System > Power Options > Shutdown > Default action selection. A dialog allowing the user to cancel the procedure will be shown in the process. Further information can be found under Shutdown.
  • Shutdown/suspend (system default action without dialog): The device will be shut down or placed in a standby mode depending on the setting under System > Power Options > Shutdown > Default action selection. The user cannot cancel the procedure.
  • Reboot (with dialog timeout): The device will reboot. A dialog allowing the user to cancel the procedure will be shown in the process.
  • Reboot (without dialog): The device will reboot. The user cannot cancel the procedure.
  • Enter custom command here: Command to be executed.