Configure which area should be visible for the setup administrator.

If a password was set up for the administrator, the IGEL Setup can only be opened with administrator rights, i.e., after entering the password (see Password). However, individual areas of the setup can be enabled for the setup administrator.

To enable setup pages for the setup administrator, proceed as follows:

  1. Here, enable those areas to which the setup administrator is to have access.

    Possible settings:


    NodeSetup Page

    not visiblenot visible

    visiblenot visible

    visibleconfigurable

     If you enable a setup page on the lower levels, the node points required for access will automatically be marked as visible (but blocked for editing purposes).

  2. Under Security > Password, enable the password for the administrator and the setup administrator.

    If administrators are to be allowed to edit parts of the setup even without a password, create a quick setup session, the password for the setup administrator will not be enabled in this case.