Menu path: Setup > Devices > Printers > TCP/IP > COM 1

  • Activate TCP/IP printers on this port

    ☑ Maps the interface defined below in a TCP/IP port.

    ☐ Disabled (default)

  • TCP/IP port number: Port on which the interface is to be mapped (default: 3004).
  • Poll criterion: Criterion according to which the interfaces are mapped.
    • Always: Maps constantly without polling.
    • Online: Maps only if the printer is switched on.
  • Poll frequency: Amount of time between polls (default: 1 sec)
  • Speed: Input and output speed (default: 9600)
  • Parity: Parity bits that are to be used. Possible values:
    • None
    • Even
    • Odd
  • Stop bits: Use up to two stop bits. (default: 1)
  • Word width: Sets the number of bits used per byte.
    • 5
    • 6
    • 7
    • 8
  • Use RTS/CTS flow control

    ☑ Hardware flow control will be used.

    ☐ Not used (default)

  • Use XON/XOFF flow control

    ☑ Software flow control by sending start/stop signs will be used.

    ☐ Not used (default)

  • Use DSR flow control

    ☑ Hardware flow control with DSR for output will be used.

    ☐ Not used (default)