Skip to main content
Skip table of contents

How to Start Automatically the VPN During Boot

If you want to update the firmware via the VPN, you need to enable Autostart During Boot. Enabling Autostart of the control application in Network > VPN > OpenVPN > [session name] is not adequate!

  1. Go to Network > VPN > OpenVPN.

  2. Check Enable Autostart During Boot.

  3. Select one of the configured sessions.

  4. Click Set Auto.
    The session will be marked in the Auto column.
    Click Set Auto again to dectivate autostarting the session.

    The system will prompt you for key pass phrases or the eToken/smartcard PIN if necessary.


JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close