If your users change their workplace often, e.g. in a mobile workplace scenario, they might often face the problem that the local printer is not the one that is set as the default printer. 

To save your users from dealing with default printer selection, you can configure IGEL OS to automatically set the currently connected printer as the default printer. This feature works with USB printers.

Environment

  • Endpoint devices with IGEL OS 11.08.200 or higher
  • The connectable USB printers are configured on the endpoint devices; for instructions, see Printers - Configure CUPS Printers in IGEL OS
  • Endpoint Management: UMS 6.10 or higher

Enabling Dynamic Setting of the Default Printer

  1. In the local Setup or the UMS configuration dialog, go to System > Registry > print > cups > dynamic_default and enable Make connected printer default printer.

  2. Click Apply or Ok to confirm the change.

Limitations / Alternative Methods of Selecting the Default Printer

The method of automatically selecting the currently connected printer as the default printer is feasible if only one printer is connected at a time. However, if the user plugs in the preferred printer while another printer is already connected, the preferred printer will no longer be selected as the default printer as soon as another printer is disconnected and then reconnected. Also, the default printer selection may change on a reboot of the endpoint device.

Thus, if two or more printers are connected to the endpoint device at the same time, you should consider one of the following methods of default printer selection.

USB Printer Class

The printer is assigned by matching patterns. This method is recommended if the endpoint device is to be configured completely with the UMS, preferably with a profile. 

  1. Open the relevant printer under Devices > Printer > CUPS > Printers. 

  2. Edit the printer settings as described under Settings to Be Configured for Each Printer Port Type, section 'Printer Port: "USB class printer"'.

  3. Under Devices > Printer > CUPS > Printers, set the appropriate printer to Default.

USB ID of the Printer

The printer is assigned by its USB ID. This method requires access to the local Setup or remote access by shadowing; see Shadowing (VNC).

  1. Open the relevant printer under Devices > Printer > CUPS > Printers. 

  2. Click Detect devices...

  3. Select the entry with the prefix (BY USBID) and click Ok.


  4. Under Devices > Printer > CUPS > Printers, set the appropriate printer to Default.