Menu path: Setup > Devices > Printers > TCP/IP > COM 1
- Activate TCP/IP printers on this port
☑
Maps the interface defined below in a TCP/IP port.
☐
Disabled (default)
- TCP/IP port number: Port on which the interface is to be mapped (default: 3004).
- Poll criterion: Criterion according to which the interfaces are mapped.
- Always: Maps constantly without polling.
- Online: Maps only if the printer is switched on.
- Poll frequency: Amount of time between polls (default: 1 sec)
- Speed: Input and output speed (default: 9600)
- Parity: Parity bits that are to be used. Possible values:
- Stop bits: Use up to two stop bits. (default: 1)
- Word width: Sets the number of bits used per byte.
- Use RTS/CTS flow control
☑
Hardware flow control will be used.
☐
Not used (default)
- Use XON/XOFF flow control
☑
Software flow control by sending start/stop signs will be used.
☐
Not used (default)
- Use DSR flow control
☑
Hardware flow control with DSR for output will be used.
☐
Not used (default)