Skip to main content
Skip table of contents

Enabling UEFI Secure Boot in UD7-W10 10

Prerequisites

  • Microsoft Windows IoT 4.03.100 or higher

UD7-W10 10 supports UEFI Secure Boot by default and no BIOS update is necessary.

It is crucial to set a BIOS password to prevent users from disabling Secure Boot.

Activating the Secure Boot Feature

  1. Turn on (or restart) the IGEL device.

  2. During boot, hold the [DEL] key until you see the Front Page screen shown below.

dd3e9b28-30a6-4cb5-87a4-3f1cc459ceda.png

  1. In the Administer Secure Boot screen, you will find Erase all Secure Boot Settings and Restore Secure Boot to Factory Settings set to <Disabled>.

  1. Change both Erase all Secure Boot Settings and Restore Secure Boot to Factory Settings to <Enabled>.
    If Enforce Secure Boot is not grayed out as in the picture below, change that option to as well.

2ad76ef1-082f-4ab0-abe2-cbf43e91f9ee.png

  1. Save the changes. To do this, press [F10] and confirm Exit Saving Changes with [Yes].


    The changes will be saved and the device will be rebooted.

  2. As a last step, verify that Secure Boot is working, see Verifying that Secure Boot is Enabled .


JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close