Skip to main content
Skip table of contents

Mainboard and Rear Outer Casing

  1. Push the retaining clips carefully aside to remove the memory.

  2. Plug out the tactile sensor (1), LED (2), speaker (3), and serial port (4) cables.

  3. Loosen the six screws and the two standoffs.

  4. Remove the rear outer casing.

  5. Remove the mainboard from the chassis.

  6. Detach the EMC gaskets.


JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.