Skip to main content
Skip table of contents

Disassembly Guide

This step-by-step guide shows you how to skillfully disassemble IGEL UD7 model H860C.

Pay attention to Safety Instructions 7!

16563-20240710-100015.png

WARNING

  • The disassembly of the device must only be carried out by an electrically qualified person.

  • Touching live parts can cause danger to life and limb from electric shock.

  • Disconnect the device from the power supply before the disassembly.

  • Disconnect all peripherals from the device before the disassembly.

  • Use only insulated tools for the disassembly.

Read this guide carefully and in full and perform the steps in the given sequence. 

Safety Instructions
Tools and Equipment
Positioning the Device of UD7 H860C
Foot Stand
Rubber Feet (If Available)
Upper Cover
Metal Panel of UD7 H860C
Smartcard Reader (If Available)
WLAN and Bluetooth Module (If Available)
Mainboard and Rear Outer Casing
Bottom Cover and Chassis of UD7 H860C
Serial Port
Heat Sink
Battery
Tactile Sensor and LED of UD7 H860C
Speaker and Label Holder
Power Supply Cable
Power Supply Unit
Disposal
JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close