Skip to main content
Skip table of contents

COM 1 / 2

Menu path: Setup > Devices > Printers > TCP/IP > COM 1

Activate TCP/IP printers on this port

☑ Maps the interface defined below in a TCP/IP port.

☐ Disabled (default)

TCP/IP port number
Port on which the interface is to be mapped (default: 3004).

Poll criterion
Criterion according to which the interfaces are mapped.

  • Always: Maps constantly without polling.

  • Online: Maps only if the printer is switched on.

Poll frequency
Amount of time between polls (default: 1 sec)

Speed
Input and output speed (default: 9600)

Parity
Parity bits that are to be used. Possible values:

  • None

  • Even

  • Odd

Stop bits
Use up to two stop bits. (default: 1)

Word width
Sets the number of bits used per byte.

  • 5

  • 6

  • 7

  • 8

Use RTS/CTS flow control

☑ Hardware flow control will be used.

☐ Not used (default)

Use XON/XOFF flow control

☑ Software flow control by sending start/stop signs will be used.

☐ Not used (default)

Use DSR flow control

☑ Hardware flow control with DSR for output will be used.

☐ Not used (default)

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.