Skip to main content
Skip table of contents

Disassembly Guide of UD2 M250C

This step by step guide shows you how to skillfully disassemble IGEL UD2 model M250C.

Pay attention to Safety Instructions of UD2 M250C !

16563-20240710-100015.png

WARNING

  • The disassembly of the device must only be carried out by an electrically qualified person.

  • Touching live parts can cause danger to life and limb from electric shock.

  • Disconnect the device from the power supply before the disassembly.

  • Disconnect all peripherals from the device before the disassembly.

  • Use only insulated tools for the disassembly.

Read this guide carefully and in full and perform the steps in the given sequence. 

Safety Instructions of UD2 M250C
Tools and Equipment
Positioning the Device
Foot Stand of UD2 M250C
Rubber Feet (If Available) of UD2 M250C
Upper Cover
Metal Panel
Mainboard and Rear Outer Casing
Bottom Cover and Chassis
Tactile Sensor and LED
Transponder
Speaker and Label Holder
Heat Sink
Battery
Power Supply Cable
Power Supply Unit
Disposal
JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close