Ifconfig
Apart from configuring network devices, ifconfig also gives diagnostic information such as RX bytes, TX bytes and dropped packets.
| IGEL Setup > |
| > Disable ifconfig logging | debug.tools.netlog.ifconfig.disabled | true / false |
| By default Ifconfig logging is included in Netlog logging. However, you can disable it here. |
| IGEL Setup > |
| > Log only if ifconfig output changes | debug.tools.netlog.ifconfig.log_on_changes_only | no,error_counter,all |
| - no: log on every netlog run
- error_counter: log only if an error counter or the address changes
- all: log on every change of ifconfig output
|
| IGEL Setup > |
| > Number of Rotate files | debug.tools.netlog.ifconfig.num_rotate_files | 2 ... 4 |
| Keep up to this number of rotated files (also compressed), the current log not included (which is limited to 600 lines). |
| IGEL Setup > |
| > Logfile rotate size in MiB | debug.tools.netlog.ifconfig.rotate_size | 2, 4, 6 |
| Rotate when the size of the uncompressed file reaches this size in MiB. |
| IGEL Setup > |
| > Trigger tcpdump log | debug.tools.netlog.ifconfig.trigger_tcpdump_save | true / false |
| Trigger the saving of tcpdump logs if an error counter increases or if the IP address changes. |