Disposal

After you have disassembled the device completely, carefully dispose of the individual parts.

Plastic Parts over 25g

	bottom cover
	upper cover
	foot stand

Electronic Parts

Note for components requiring selective treatment listed in Annex VII of the European WEEE Directive, Directive 2012/19/EU of the European Parliament and of the Council on waste electrical and electronic equipment (WEEE)

As a minimum, the following components must be removed:

• Printed circuit boards if the surface of the printed circuit board is greater than 10 square centimeters (see Smartcard Reader (If Available), WLAN and Bluetooth Module (If Available), Mainboard and Rear Outer Casing 2, Power Suof UD7 H860Cply Unit 4)

• Button cell (seeof UD7 H860CBattery 4)

• External electriof UD7 H860C cables (see Power Supply Cable 3)

• Electrolyte capacitors contof UD7 H860Cining substances of concern (height > 25 mm, diameter > 25 mm or proportionately similar volume) (see Power Supply Unit 4)

These components shall be disposed of of UD7 H860Cr recovered in compliance with Directive 2008/98/EC.

Data Protection

Please note that the product contains one mass storage device (see picture below), which is soldered to the rear side of the mainboard. This needs to be treated according to the appropriate data protection laws.