Skip to main content
Skip table of contents

Drive Mapping

Menu path: Sessions > RDP > RDP Global > Mapping > Drive Mapping

Through drive mapping, connected mass storage devices can be made available in the session. Specify which folders or drives are mapped during the login.

Enable Drive Mapping

Drive mapping is enabled. (Default)

Local (USB) devices which are to be used for drive mapping purposes must first be set up as devices. See Storage Hotplug.

Before you unplug a hotplug storage device from the endpoint device, you must safely remove it. Otherwise, data on the hotplug storage device can be damaged. Depending on the configuration, there is one or several possibilities to safely remove a hotplug storage device:

  • Click on image-20240610-073414.png in the task bar. The taskbar is not available in a fullscreen session.

  • Click on image-20240610-073419.png in the in-session control bar. Depending on the configuration, the in-session control bar may be available in a fullscreen session. For further information, see In-Session Control Bar.

  • Function Accessories > Safely Remove Hardware with further starting possibilities; amongst other things, a hotkey can be defined here.

    If the following warning is displayed: Volume(s) still in use. Don't remove the device, then the hotplug storage device must not be removed. First, exit the program concerned or close all files or directories that reside on the hotplug storage device.

Drive Mapping: List of mapped drives.

To set up drive mapping, proceed as follows:

  1. Click image-20240610-073434.png Add to bring up the mapping window.

  2. Click Enabled to enable the drive connection.

  3. Select a Drive to map from the list under which the local device or the folder is to be mapped.

    If the drive letter you have selected is no longer available on the server, the specified directory or local drive will be given the next free letter during the login.
  4. Give the Local Drive Path of the local directory to which the mapping is to refer.

    If you map a locally connected device, use the pre-defined path names available in the drop-down field. The directories in question are those on which the devices are mounted by default during the boot procedure (e.g. /autofs/floppy for an integrated floppy drive).



JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.